FACE FRAMES (OAK)

• Mortise and tenon, glued and fastened

• Horizontal rails 3/4" x 1-1/2" kiln dried hardwood

• Vertical stiles 3/4" x 1-1/2" kiln dried hardwood

CABINET ENDS

• Exposed ends 1/2" 45# premium particle board

• All wall cabinet ends rabbeted to receive tops, bottoms

• Base cabinet ends are rabbeted to receive floor and intermediate shelf

CABINET DOORS AND
DRAWER HEADS (OAK)

• Doors -Five piece oak square frame door with plywood panel in rabbet. All joints tennoned and coped, profile: back beveled

• Drawer Heads -Solid kiln dried oak -3/4" thick,profile: back beveled

DRAWERS

• 7/16" fiberboard basecoated, printed, topcoated (4 sides)

• Bottom 1/8" hardboard, matches interior Sides rabbet joint machined all four corners

• All joints glued and power nailed
  
  

WALL CABINET AND BASE CABINET SHELVING

• Shelving 5/8" premium particle board with front edge smooth, fully adjustable in all wall cabinets
• Due to plumbing considerations, there is no shelving in sink bases or vanities
• Base shelf is half depth
  

WALL CABINETS TOP AND BOTTOM

• Wall cabinets not less than 1/2" 45# particle board
• Let into sides and face frame All joints glued and power nailed

BASE CABINET FLOORS

• Base cabinet not less than 1/2" 45# particle board
• Let into sides and face frame All joints glued and power nailed Back of floor set on supporting member, glued and fastened

HARDWARE

• Self-Closing, 110 degree opening concealed hinges.
• Drawer slides - side mount, 75 Ib load capacity, epoxy coated, self-closing
  

CABINET BACKS

• All back are 1/8" standard hardboard
  

FINISH

• Conversion Varnish -a hard durable finish that is non-yellowing and offers excellent chemical resistance
• All exposed interior sides, shelving and wall cabinet bottoms, GrandLam clad (except hang rail)
• Cabinet has been tested and certified by National Kitchen Cabinet Association as meeting American National Standards Institute specifications ANSI 1611